Kicccc
1
hi,
my stuff that printed out looks like this, can anybody figured it out what’s wrong with my settings?
Settings: layer thickness:0.200mm, extrusion width:0.375mm, filament flow:100%, print speed:30mm/s, retraction amount:2mm, retraction speed:6mm/s, minimal travel before retraction:1mm, retraction z-hop 0.150mm, temp. 205degree, heated bed off
printer: M3D pro
slicer:M3D
material: PLA
New:
The smaller object is using the same file but resized.
--pics–
side: https://i.stack.imgur.com/UYMBP.jpg
top: https://i.stack.imgur.com/Kux1J.jpg
inside of the left object: https://i.stack.imgur.com/dTjoU.jpg
side of large object: https://i.stack.imgur.com/omdKQ.jpg
20x20x20 cube: https://i.stack.imgur.com/mAYlS.jpg
-–files—
new
calibration cube | Files.fm.