1

I have followed the instructions on this page on switching the endstops to see their status and i have determined that my y endstop terminal always reports the endstop being triggered. https://printrbot.zendesk.com/hc/en-us/articles/208275723-Auto-Leveling-Probe-Triggered-vs-Open

I have also tried reflashing firmware multiple times and nothing has happened. Please let me know of any additional information you might need.

Cheers,

Alexander’s Hub

2

Hi Alex

If you want support, have you tried opening a ticket on the PB support site? If the cable is broken, it will also report as triggered as they are wired as normally closed.

Check the wiring and the switch with a meter. You may need to get the soldering iron out! :slight_smile:

3

I made a support ticket at the same time as this thread I just wanted multiple opinions on this matter. I also checked the switch with a multimeter and it is normally closed and does go open when triggered.