Hey y’all I’m trying to get my Annette A8 printer up and going and I started running a test print on the pyramid today and you can see that it went okay for a while but then it went off haywire and was just printing lines all over the place. Hoping you guys have a suggestion for me. Thanks in advance. I set the machine at 190.
I would try the print again and watch it and see what happens when it goes bad. Does a cable bunch catch on the back of the print and trow things off.
Try a different model and see what that does.
jfield
3
Hard to tell from pics, but maybe you do not have good adhesion/squish on first layer.
Now that I look at this again the tape could be an issue. 3M blue painters tape is one of the few that actually work from what I have read.
So, first thing is to get a proper bed set up.
I also neglected to use hairspray
