1

Hello everyone,

I see that my abs prints will bow some after the print is done. It doesn’t bow during but after. Interesting enough I made a abs print with 100 percent infill and made it so that it was like a 90 degree bar and there was no bowing at all. I put a ruler on it and it is flat. The other prints are bowed off about 1/16" every foot when I put the ruler on it. The usual prints I make are 30 percent infill. Does anybody have any idea why this happens.

Thanks

2

I wonder if the bowing would increase if you dropped the infill to 5 or 10, or decrease with an infill of 50 or 60? Some kind of contraction that is minimized as the density increases?