We just put everything together on our anycubic kossel (delta-style) and finally got a great print after buying some blue painter’s tape and we went to sleep. We woke up and one motor wouldn’t work.
I tested it on specific movement and the motor does go down when told to manually, just not up.
We reset our firmware twice.
-It was saying one of the endstops were triggered.-
Our print area is 180mmx180mm circle with 300mm height.
We think it is the endstops (whatever those are, we are unsure!). I unplugged and plugged everything in and nothing changed.
We ran M119 and it said all the endstops were open.
HELP! THANK YOU<3!
