Hi I am looking for someone to print me a 1mm pitch timing belt, There are plenty of 2mm designs
Here is the spec
> 1mm pitch
> no. teeth = 134
> length = 138mm
> width 3.8mm
The application is for an anti skate belt for a Rega 200 tone arm, there is little or no torque involved
Any advice/design?
I did find a GT2 belt
customiser at MakerBot account for file
Customizable GT2 timing belt by Anteino - Thingiverse But not sure of the parameters in the customizer app to change to achieve this
> P = 1mm?
> R1 ?
> R2 ?
> R3 ?
> B ?
> H?
> H ?
> I?
> Pld?
> Thickness 3.8mm?
> teeth amount = 138?
> H?
I asked the designer last week but got no reply
I have no experience of openscad so could someone take pity on me…
Kind Regards Peter