I’ve been having issues with my maker ultimate since I got it (about a week ago). In general the prints looks decent but there’s been a lot of over extrusion, weird stringing, warping etc.
I went through about 5 calibration cubes and found that no matter what I did, it was printing high on the left side like it was over extruding but only on that left side.
After closer inspection I noticed that the bearings on the z axis rods are higher on the left side and I’m not sure which bolts to loosen to adjust it. I know with the Maker Select Plus there’s a printable jig by Antscran that helps you align the z axis by pushing it down into the jig.
Is there a simple way to adjust my bearings without unbolting anything?
