1

Hello,

So I am going to enlist my printer on 3D HUBS. I am currently waiting on the address verification post card to enter for the print quality review. If I am not mistaken, this review requires you to print a Marvin at 100 micron resolution?

I was wondering if this Marvin (5th attempt) would be good for review? I know that the back of this one is not perfect, but I found a solution for that.

Thank you in advance!

20170405_165034419_ios.jpg
20170405_165034419_ios.jpg2706×2705 706 KB
20170405_165043025_ios.jpg
20170405_165043025_ios.jpg2555×2554 593 KB
20170405_165051465_ios.jpg
20170405_165051465_ios.jpg2448×2447 549 KB
20170405_165107206_ios.jpg
20170405_165107206_ios.jpg2469×2468 541 KB
20170405_165114245_ios.jpg
20170405_165114245_ios.jpg2324×2323 507 KB
20170405_165122184_ios.jpg
20170405_165122184_ios.jpg2390×2389 520 KB
20170405_165127555_ios.jpg
20170405_165127555_ios.jpg2354×2353 495 KB
20170405_165137595_ios.jpg
20170405_165137595_ios.jpg2056×2055 455 KB

2

Its also not is this good enough. You need to think of the customer, would they be happy with this?

You have some spots on the side of the leg that look like indents from filament missing

8 Likes
3

I found the cause of the spots.