Main board replacement.

Ice203 · 2017-01-27T19:54:12.000Z

I have a tronxy x3 but having problems with the main board so looking for some advise on what board I can change it to.

Teneopeto · 2017-01-30T08:59:53.000Z

i swapped mine to an arduino with ramps and a bltouch sensor in stead of the orirgnal z axis sensor. That works great.

Mirth · 2017-01-30T09:21:26.000Z

GT2560 or RAMPS 1.4

Michele_Soraruf · 2017-01-30T14:36:52.000Z

Hi, I saw this board here and it has wonderful features… check it out: http://www.reprap.org/wiki/Megatronics\_2.0

DomoticX · 2017-01-30T15:55:39.000Z

I would go for a RAMPS setup (Arduino MEGA + RAMPS + DRV8266’s) with Marlin firmware, it’s also very good supported by the community!

Mirth · 2017-01-30T16:02:03.000Z

Had nothing but bad luck with DRVs… there’s some very fine tuning that needs some apparently. Good ol’ pololus work excellently for me!