Hi
First post here on the forum.
I’m building my second 3d printer Kossel Detla design.
All built just setting the Firmware to work correctly.
Managed to get the Y & Z axis to move after some small issues, but X axis is a real pain. Not moving at all. No matter what I do with the Stepper motor control on the mainboard it will not move.
I do get a noise from the motor when I turn the resistor a small amount, move it again and nothing happens when I press the homing button on the Repetier software.
Any Ideas on how to resolve this problem.
Once this is working Then onto the next stage calibrating the heights etc.
Regards
Mike
