Jaycar '3D printer kit'

Dank555 · 2016-12-11T05:22:15.000Z

I bought a Jaycar ‘3D printer kit’ a while ago and I haven’t been able to make it communicate with the Repetier Host software correctly. It has a bit of communication with the software but doesn’t seem to be talking to it properly. If anyone has any advice it would be appreciated.

WillPio · 2016-12-12T10:02:26.000Z

I dont know if I can help but I was eye balling this printer. So whats the software drivers? ARDUINO DUE? What controls work?

Deadpoodle · 2016-12-12T10:27:56.000Z

If it’s missing basic connectivity I’d be checking the baud rate, see what the jaycar kit is using and set repetier to match.