Hi, I haven’t had any issues printing since I received my Monoprice Maker Select on friday, and I decided to try to print a Marvin, expecting no issues.I had to adjust the print temperature down from 210C (which had been working) to 185C (bed at 60C) and I am still ending up with issues, especially on the ears. I am looking for any suggestions for fixing these prints.The right ear is always more deformed than the left. I have attached photos of my issue. Thank you for all your help.
http://imgur.com/a/1a4ex
What are you using for a slicer? Simplify 3D?
I’m using cura, I printed 4 of him at once and slowed down my print speed and was able to get much better results, I’m going to upgrade my cooling soon to avoid this issue with small prints.
