I have tried everything i can think of but i am still getting ooze to the point that most of my travel lines end up being single thickness walls. I am printing in PLA with a prusa i3. Temps i have tried are anywhere between 195-200, and retraction up to 5mm, and still getting the ooze. Any suggestions?
SOC3D
2
What brand of filament? What are your retraction settings for vertical lift and speed, what is your travel speed set to? Also check here: Print Quality Guide | Simplify3D Software
i will get those settings when i get home tonight.
Sorry it took so long to get back, been busy. The brand filament is “inland” yes it is cheap stuff, but i have been printing with this brand for over a year and have never had this issue. My settings are:
Retraction = 3 - 10mm
Retraction Speed = 20 - 50
Z Lift = 2mm
Nothing has changed, i never used to have any of these settings and my parts came out perfect, now my parts require so much “cleaning up” i am tempted to just throw them in the recycle pile.
