I bought the printer and ran the single extruder test print from the SD card that was provided and it turned out nice. Then I installed simplify and ran it but I think that made the printer a little confused because x, y, and z coordinates were all off. I turned off the printer and unplugged the pc from the printer and when I ran the bed leveling program the extruder ran off the bed while doing the test and the BL touch needle took a pretty nasty hit on the bed. At this point, my printer is sitting with the second extruder that’s jumped the belt and is making a grinding noise when moving and the same goes for the z axis motor. Is there a reset button or a way to re calibrate all of this???
