Ok I have an Flsun Kossel Delta 3D printer all built, firmware flashed and repetier host installed. When I run G29 it does its multi point auto leveling but the hot end doesn’t touch the bed . What am I doing wrong?
I have this exact problem! Im totally new to 3d printing. FLsun Kossel Delta running 1.1.0-RC-AC. I run the G33 autoleveling and it levels out very nicely (as far as i can tell) than when i try to print, it starts printing about 4in off the bed?! Im sure its something easy im missing in the settup but what? any help out there?
Actually I finally got mine working. I personally took my printer apart about 3/4 of the way and found two broken wires, soldered them and then went back into configuration.h in Marlin and carefully went through to set up my basic settings. I found a real size printable me ruler online and got as close as I could on accuracy with my measurements on the basic settings. Re-uploaded to Marlin and whallah
