Hi
Ok so, my nozzle got blocked and so I unblocked it as I’ve done many times before but while I was on replaced the nozzle, ptfe tube and the kapton insulation.
I also replaced the micro servo motor as this was dead.
Now, when I print, same material same temps as I’ve always done (210c) for formfutura PLA them temp seems way off.
The PLA is oozing out like liquid and the colour is darker (it’s a light grey) and so I know them temp is too high. Thing is the thermocouple still reads 210c, plus I’ve swapped this out with a spare I had and it’s the same, any ideas?
Tom
