My printer was displaying red lights earlier. What do they mean. Also, during printing on occasion the printer plays some tones/music. I kind of associated that with a filament feed problem but I have no idea if there’s a filament sensor or not. I haven’t found a manual for this printer that describes anything but initial set up. Does one exist?
Hi, I asked myself the same questions when i got my creator pro! I think the red lights indicate either print nozzles or print bed is in the process of heating up, and the sounds are purely for effect - they can be turned off through the settings menu.
1 Like
Red lights (leds above the door? ) before the print started? If so then it’s what it does when it’s heating up (or at least used to for me) As for the music, no idea, it confuses me, some times it plays when changing from one stage to another (ie print process 1 to process 2 in simplify3d) or when the bed is up to temperature and the nozzle starts heating (pre print) but other times its just randomly throughout the print. Doesn’t seem to signify anything too significant so I just quickly glance at it when ever I hear the music haha. Hope that helps
I kinda figured out that the music plays when the nozzles or bed get to temp. I wonder if my printer couldn’t benefit from a PID tune as the temps jump around a bit and when they drop below their target temps and then creep back up the printer plays a little tune which is annoying at best.
