Anet A8 Issues

ThePoligoncube · 2017-01-11T21:22:27.000Z

So, basically I got the anet A8 DIY kit from Gearbest.com and everything was fine but I notice that when the extruder hits the X Axis Endstop switch the LCD Turns off and when I release it the Printer Restarts … I was wondering if anyone could help me fix this

20170111_161456_0.jpg3264×1836 1.14 MB

20170111_161530.jpg3264×1836 1.72 MB

ThePoligoncube · 2017-01-11T21:22:56.000Z

Please help

Bradley4832 · 2017-01-12T12:22:56.000Z

You most likely have the x axis endstop switch connected into the wrong hole, it can get confusing when there are that many wires going around. Try rewatching the build video and make sure all the wires are attached correctly.