1

So I just started 3D printing and I have a Monoprice Maker Select V2. I am currently printing http://www.thingiverse.com/thing:776322 . I am using Cura 2.4. The infill is set to light but I am looking at the actual print and it looks to be going solid. I printed a fidget spinner before this and it also seems pretty tough.

The difference in time between light and solid for this specific keychain is only 1 minute. Could it just be this model?

2

Well, the model is too thin, your bottom and top layers are so close or even merged.

To confirm this, your model height must be less or equal to top + bottom wall thickness set in Cura.

3

that looks quite thin between the solid top and bottom layers which will be solid there may be only 1 or 2 layers of infill.Click on view mode (eye on the left) then layer mode to get a preview of what it is going to do by layer.

4

Ok, I’ll do a benchy and see how it turns out.