I’m a complete newbie and have just finished the hardware assembly of this delta printer from Gearbest but following the manual I tried to use the auto leveling feature. I’ve seen videos on YouTube of this taking place but my printer just doesn’t perform the same actions.

Instead of the head going down to the bed and selecting the test points it just goes up to the top of the frame to the end stops and after clicking these a few times just moved the head down about 4 cms and stops.

I’ve double checked all the wiring but cannot see anything wrong. The firmware was already installed when the printer kit came but do I have to download a new version or something.

Can anyone advise please.

Many Thanks in advance for any help


1 Like

have the same problem. did you find what was wrong